arp rod bolts and machining???
#1
Honda-Tech Member
Thread Starter
arp rod bolts and machining???
What's up ht I have a set of arp rod bolts that I plan on using on my ls rods for a lsvtec build and my question is: must I have the big end of the rod honed? And if so would I use an oversized rod bearings?
#2
Honda-Tech Member
Join Date: Aug 2005
Location: Nova Scotia, Canada
Posts: 138
Likes: 0
Received 0 Likes
on
0 Posts
Re: arp rod bolts and machining???
You should have it checked (and probably resized) but you will not have to use oversize bearings unless your clearances on the rod journals of the crank require it.
(They should be able to make it round again without oversizing the journal of the rod)
So as long as your crank measures good you should be okay.
(They should be able to make it round again without oversizing the journal of the rod)
So as long as your crank measures good you should be okay.
Thread
Thread Starter
Forum
Replies
Last Post
itr_henrik
All Motor / Naturally Aspirated
14
05-25-2007 02:08 AM