Honda-Tech - Honda Forum Discussion

Notices
Search: Posts Made By: Pilot
Showing results 1 to 15 of 15
Search took 0.65 seconds.
Forum: Forced Induction
04-14-2006, 09:17 AM
Replies: 15
Views: 12,095
Posted By Pilot

Re: AFR range with water/methanol injection (Tony the Tiger)

Good points to consider.

Interestingly the theme of water methanol system failing comes up over and over. If ANY component fails under full load like fuel injector, fuel pump, coil, etc then...
Forum: Forced Induction
04-12-2006, 07:04 AM
Replies: 15
Views: 12,095
Posted By Pilot

Re: AFR range with water/methanol injection (quickergixxer)

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by quickergixxer &raquo;</TD></TR><TR><TD CLASS="quote">these kits come with software? could you just...
Forum: Forced Induction
04-11-2006, 08:30 PM
Replies: 28
Views: 1,457
Posted By Pilot

Re: Running 1000cc, what is the best resistor box to get? (96 GSR-T)

The FJO Injector driver box actually drives peak and hold injectors at high current peak and hold. It's not just a resistor box! A resistor box only protects a low current OEM style injector drive...
Forum: Forced Induction
04-09-2006, 08:37 AM
Replies: 15
Views: 12,095
Posted By Pilot

Re: AFR range with water/methanol injection (purpleh22)

Generally we recommend an AFR of 12.5:1 when using pump gas and FJO water/methanol injection system. Also if you are using race fuel and water/meth you can reduce the volume of injected water/meth....
Forum: Forced Induction
03-27-2006, 12:41 PM
Replies: 5
Views: 654
Posted By Pilot

Re: Is this a good Deal - for a Fjo Wideband Unit + Ntk o2 (JoKeRX)

Hey thanks for the feedback!
You were probably talking to Gerald. He's head of tech support for FJO.

Thanks again,

Ross.
Forum: Forced Induction
03-19-2006, 06:56 AM
Replies: 8
Views: 873
Posted By Pilot

Re: breaking up in boost (victoriasamantha)

For boosted engines, spark plugs gaps are typically 0.022-.028. Gap it down and re-try.

Ross.
Forum: Forced Induction
03-12-2006, 08:06 AM
Replies: 120
Views: 8,307
Posted By Pilot

Re: 476whp on Stock sleeves!! (lalspeed)

There is no substitute for a good tune and build. All of this destruction was caused solely by detonation. The stock sleeve did not fail. It was DESTROYED by detonation.
5th gear top end runs are...
Forum: Tech / Misc
03-08-2006, 07:54 PM
Replies: 5
Views: 2,319
Posted By Pilot

Re: EGT gauge, needed for tuning? (locash)

Fuel tuning is best left to a wideband O2 since many factors affected EGT reading other than just AFR. However, I use the EGT to help dial in the ignition timing after we've tuned out the AFRs. I've...
Forum: Tech / Misc
03-01-2006, 08:39 PM
Replies: 4
Views: 1,039
Posted By Pilot

Re: O2 Sensor w/ Race Gas... (LSEGHATCH)

Generally the wideband O2 sensors made by NTK will withstand a certain amount of lead contamination before readings are significantly affected. Also, generally, Bosch sensors die almost instantly (or...
Forum: Forced Induction
02-27-2006, 07:03 PM
Replies: 14
Views: 18,038
Posted By Pilot

Re: 50 trim vs 57 trim, T3/T04E on D16 (spooncivic1)

What brand of T4oE are you looking at?

From the InnovativeTurbo.com website looking at both compressor maps for T4oE-50 and 57, the 50 trim by every measure is the better choice including...
Forum: Forced Induction
02-24-2006, 07:23 AM
Replies: 17
Views: 1,416
Posted By Pilot

Re: Hondata/Romulator/FJO Injector Driver/IACV = Wierdness (Blown90hatcH)

Given the nature of the electrical problems on your car I would suspect strongly that there is a ground loop condition. Improper or floating grounds cause all manner of problem with electronics....
Forum: Forced Induction
02-16-2006, 08:19 AM
Replies: 70
Views: 5,972
Posted By Pilot

Re: (locash)

We've redesigned the FJO injector driver unit so it has an even simpler install (only 5 wires now). The first generation design, the one's Alamo were selling, were clearanced priced to make way in...
Forum: Forced Induction
02-15-2006, 09:02 PM
Replies: 70
Views: 5,972
Posted By Pilot

Re: (servion)

Hi,

Alamo is one of our primary U.S. dealers. They have been with us for years and do a good job for FJO customers. They're good people to know. Nitrous Express is also an FJO dealer and carries...
Forum: Forced Induction
11-19-2005, 08:21 PM
Replies: 19
Views: 7,109
Posted By Pilot

Water methanol injection works very well. This...

Water methanol injection works very well. This summer our team tuned a 69 Camaro street car using the FJO electronic water methanol injection system and it ran 7.81 at 183 on 91 octane pump. In fact,...
Forum: Forced Induction
11-18-2005, 07:21 PM
Replies: 42
Views: 8,763
Posted By Pilot

Re: (VTEC-IKE)

I'm trying to understand the need for such a system. If the "problem" is limited traction then a clock-based boost control system will be to little or value. Only a true driver controlled system will...
Showing results 1 to 15 of 15


 
Forum Jump


All times are GMT -8. The time now is 03:47 PM.