dirtylilhonda

does anyone know where i can find out how to wire a 95 obd I distributor to a 96 obd II car that is ran from a obd I ecu. that sounds confusing i know.

SikB

The second post under "Poison's OBD1 ~> OBD2 distributor Diagram" - https://honda-tech.com/zerothread/650329

dirtylilhonda

THANK YOU SO SO SO MUCH!!!!!!!

dirtylilhonda

well there is a problem... thats for a h22 into a civic. my wires aren't matching up with it. i have like 3 different. but it helps .

mgags7

check the "hybrid" forum down below on the honda-tech main page. There is a thread about swapping h22s into civics there that has all the info you need.

dirtylilhonda

no i'm sorry i must be saying the wrong thing. i have a 96 prelude. h23. i put a 95 h23 back in it. i used my 96 harness and a jumper harness with an obd I ecu. i now have to use a obd I dizzy. i need to know how to wire the obd I dizzy to my 96 obd II harness. i know i have to use the wires that were going to my crank postion sensor for the cam postion in the dizzy but i'm not sure which wire goes where i was hoping that some has done this and could help me with that. the link that he posted on here was for a h22 into a civc so the wires don't exactly match mine.

mgags7

use that thread, the wiring is the same.

dirtylilhonda

when i was looking at it and my car there were like 2 or 3 that didn't match the diagram. they are differnet colors. is that for a internal coil or external?

mgags7

whoops I forgot to mention that.

Your car will not need to be wired to change to external coil, because it already is.

The only wires you should have to deal with are the 4 for the 2 added sensors.

dirtylilhonda

i don't have the dizzy yet but your saying all the wires are the same except the sensors that are in it. right? which i can run from the crank sensor? right?i found someone on here that has done this exact swap before but i can't catch him online. do you know jdmlude5? i'm jus not too good with wiring.