Knock Sensor! Do the wiring connect at the top or bottom of the connector?
#1
Honda-Tech Member
Thread Starter
Join Date: Nov 2005
Location: Mechanicsburg, PA, Cumberland
Posts: 684
Likes: 0
Received 0 Likes
on
0 Posts
Knock Sensor! Do the wiring connect at the top or bottom of the connector?
My Knock Sensor wire was pulled out from the connector. I can't seem to figure out which part of the connector to connector the red and blue wire.
#2
Honda-Tech Member
Thread Starter
Join Date: Nov 2005
Location: Mechanicsburg, PA, Cumberland
Posts: 684
Likes: 0
Received 0 Likes
on
0 Posts
Re: Knock Sensor! Do the wiring connect at the top or bottom of the connector? (JBirch_97Prelude)
I switched them back and fourth and I am still throwing code 23. I even put electrical tape over the exposed wire and it continues to throw code 23 when I go over 3000 rpm's for more than 3 seconds.
#4
Junior Member
Join Date: Mar 2004
Location: Southern, NY, US
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
Re: Knock Sensor! Do the wiring connect at the top or bottom of the connector? (JBirch_97Prelude)
the side nearest the clip.
when in doubt, use a new 2-pin plug and wire both pins together
when in doubt, use a new 2-pin plug and wire both pins together
#5
Honda-Tech Member
Thread Starter
Join Date: Nov 2005
Location: Mechanicsburg, PA, Cumberland
Posts: 684
Likes: 0
Received 0 Likes
on
0 Posts
Re: Knock Sensor! Do the wiring connect at the top or bottom of the connector? (cpmike)
Thanks alot, what if it still throws a code? Could the Sensor have shorted out when I accidently knocked the wire out?
Thread
Thread Starter
Forum
Replies
Last Post