ABS light after engine swap
#1
Honda-Tech Member
Thread Starter
Join Date: Sep 2005
Posts: 831
Likes: 0
Received 0 Likes
on
0 Posts
ABS light after engine swap
Throwing an ABS light shows Code1 when i jump it.
Light turns on after i get past 15-20mph
I recently did an engine swap so i am not sure if this is axle or clutch lines related or if i have to bleed the abs system or reset it in some way.
Can anyone point me in the right direction?
Thanks
Light turns on after i get past 15-20mph
I recently did an engine swap so i am not sure if this is axle or clutch lines related or if i have to bleed the abs system or reset it in some way.
Can anyone point me in the right direction?
Thanks
#3
Honda-Tech Member
Join Date: Jan 2003
Location: Texas
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
Re: ABS light after engine swap
Not sure what code 1 is but if you swapped axles you may have bent a sensor or the axles are not ones with the ABS ring on them. The ring looks like a gear on the outside of axle close to the wheel.
#5
Honda-Tech Member
Thread Starter
Join Date: Sep 2005
Posts: 831
Likes: 0
Received 0 Likes
on
0 Posts
Re: ABS light after engine swap
used the same axels. not sure what the sensors look like but i will see if i can find a pic and look into this.
#6
Honda-Tech Member
Join Date: Dec 2004
Location: Oklahoma City, OK, USA
Posts: 3,095
Likes: 0
Received 0 Likes
on
0 Posts
Re: ABS light after engine swap
Thread
Thread Starter
Forum
Replies
Last Post