HELP! MINI-ME OBD0 OBD1 questions!
#1
Honda-Tech Member
Thread Starter
HELP! MINI-ME OBD0 OBD1 questions!
I need this car running now I start a new job on Monday! My car has d15b7 block d16z6 head OBD0 to OBD1 conversion harness. My problem is that my car is starts and will idle but it boggs when I give it gas. If I barely touch the throttle it will rev up but when I step on the gas hard or go wide open throttle it boggs and will die. What can I do?
#3
Honda-Tech Member
Join Date: Mar 2007
Location: SF !
Posts: 725
Likes: 0
Received 0 Likes
on
0 Posts
Re: HELP! MINI-ME OBD0 OBD1 questions!
when you're cranking your car, does it take longer than usual to fire up?
what belt/cam gear are you using?
CEL??
what distributor are you using?
i'd check for these :
-timing
-map & tps mixed up
what belt/cam gear are you using?
CEL??
what distributor are you using?
i'd check for these :
-timing
-map & tps mixed up
#4
Honda-Tech Member
Thread Starter
#5
Honda-Tech Member
Thread Starter
Re: HELP! MINI-ME OBD0 OBD1 questions!
I have no CEL codes check engine light stays off. I'm using the d16z6 distributor. The map and tps are in the right place for sure. I'm using a d16z6 timing belt and the cam gear is off of a d16y7 head I had sitting around but it has the same amount of teeth and diameter.
#7
Keyboard Humorist
Join Date: May 2002
Location: Granada Hills, Ca, USA
Posts: 9,814
Likes: 0
Received 9 Likes
on
7 Posts
Re: HELP! MINI-ME OBD0 OBD1 questions!
Sounds like your timing is off. Not sure if the standard 1/2 a tooth cam timing error applies just because the deck height differences between the two engines so you may need a cam gear to correct that.
Sounds like your ignition timing is giving issues which would be your main reason for the stalling.
Sounds like your ignition timing is giving issues which would be your main reason for the stalling.
Trending Topics
#8
Honda-Tech Member
Join Date: Jul 2008
Location: Canada
Posts: 326
Likes: 0
Received 0 Likes
on
0 Posts
Re: HELP! MINI-ME OBD0 OBD1 questions!
Sounds like your timing is off. Not sure if the standard 1/2 a tooth cam timing error applies just because the deck height differences between the two engines so you may need a cam gear to correct that.
Sounds like your ignition timing is giving issues which would be your main reason for the stalling.
Sounds like your ignition timing is giving issues which would be your main reason for the stalling.
Thread
Thread Starter
Forum
Replies
Last Post
Alex Shelley
Honda Civic / Del Sol (1992 - 2000)
10
01-30-2019 03:20 PM