driver side halfshaft wont go into diff
#1
driver side halfshaft wont go into diff
I just picked up my new halfshaft this morning and tried to install it (1990 CRX SI ED9)
the inner end went about halfway in and it wont go any farther, am i just not strong enough to puch it in or am i doing something wrong?
im going to be pulling it out and checking the spline count
* counteed the splines 25 on inner of both the old shaft and the new one
Should i try hitting the opposite end with a rubber mallet?
ok so i tried everything and it wouldnt go in
but when i cocked the axel forward so it was touching my oil pan it slid in with minimal effort -.-
the inner end went about halfway in and it wont go any farther, am i just not strong enough to puch it in or am i doing something wrong?
im going to be pulling it out and checking the spline count
* counteed the splines 25 on inner of both the old shaft and the new one
Should i try hitting the opposite end with a rubber mallet?
ok so i tried everything and it wouldnt go in
but when i cocked the axel forward so it was touching my oil pan it slid in with minimal effort -.-
Last edited by kyral; 01-31-2014 at 07:32 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Surfjunkie44
Honda CRX / EF Civic (1988 - 1991)
4
05-29-2011 12:53 AM