gsr_b20b

hey guys im just finishing up my d16z6 swap into my 91 cx hatch. I ordered a Zerg obd-0 to 0bd-1 conversion harness. I soldered the vtec solenoid and the vtec pressure wire and everything. But when i come to the o2 sensor wiring it does not match up with what they tell me in the instructions.

Its telling me to connect the wiring to the o2 sensor and the o2 sensor (4 wires) should have a green wire, white, black and blackwith white. But instead my o2 sensor has a blue,white and 2 black wires?

Anyone achieve this conversion with a zerg jumper harness? Any help will work

DRatedA.W.D.

Connect the green to blue, white to white and black to black both ways. One black wire is the heater wire and the other black is the 12+ wire.... if you get them backwards and it throws a code, don't worry. Just switch them.

gsr_b20b

alright thanks alot man, i was pretty stumped. Next i gotta do is multi port swap now

gsr_b20b

okay so it wont fire now. got fuel pressure, but i noticed there are two wires coming out of the dizzy that are not connected to anything. They are blue with yellow and blue with green. After research they are ckpp and ckpg, which are crankshaft position sensor wires, where do i connect them to? isnt the crankshaft position sensor behind the crank pulley on a d16z6?