Car wont rev past like 3500rpm
#1
Honda-Tech Member
Thread Starter
Car wont rev past like 3500rpm
I wired b10 and b12 to the distributor the motor is a ls in a 1990 ef hatchback.I wired to the dizzy like instructions said on MPFI conversion.But I removed the crank angle sensor from the block.Im using a chipped p75 the chip has a two step and it sounds like thats what its doing but I dont have a tach so im guessing its bout 3500 two step set at 4500 while parked I can hit two step or what I think is two step.But while driving it wont rev up more than 3500 or 4500.My brother told me crank angle wouldnt make my car go into limp mode can somebody help me.
#5
Honda-Tech Member
Re: Car wont rev past like 3500rpm
Vtec engages at a certain point for a reason, dont mess with it.
Besides, what do you need with all the excessive, and unnecessary tuning? This is a street driven car, correct?
Besides, what do you need with all the excessive, and unnecessary tuning? This is a street driven car, correct?
#6
Re: Car wont rev past like 3500rpm
a ls motor doesnt have vtec... and your throwing a code thus putting it in limp mode. check the code and fix it.
#7
Honda-Tech Member
Re: Car wont rev past like 3500rpm
EDIT: actually, he didnt specify the motor, he could have chipped that ecu to run an ls-vtec or something.
Trending Topics
#9
Honda-Tech Member
Thread Starter
Re: Car wont rev past like 3500rpm
Thats the only ecu that will run the car stock ecu wont even start it.Unless its a p28 so thats kinda pointless.
Obd1 conversion is done correct unless you are talking about purchasing a rywire engine harness.Car throws no codes.I checked it like 4 times no codes at all and yes p75 is other ls ecu from 94-95 pr4 is from 92-93 obd1 da.
Thread
Thread Starter
Forum
Replies
Last Post
Acura_I-RS
Tech / Misc
10
10-30-2005 09:06 AM