devin_hoang

I have a gsr in an eg with a chipped b16 ecu.

At times my car would go into gear and be able to drive just fine.

and there are times that the car wont go into gear at all. i would have to put it into first gear and then turn on the car and it will go.

and there are time that when i put it into gear and it wont come out at all. it'll be stuck.

would could be the problem. would it be the throw out bearing?

Frickr

sounds like your shift linkage is binding, check the conditions of your motormounts

devin_hoang

how could that be the problem?

the car goes into gear easy when the car is off.

Jonathan_ED3

Also check your slave cylinder and clutch MC.

The slave is usually the first to go.

I'd agree with Frickr - check all your mounts!

Does it freely engage/disengage with the engine turned off?

devin_hoang

yeah it does.

Jonathan_ED3

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by devin_hoang &raquo;</TD></TR><TR><TD CLASS="quote">yeah it does. </TD></TR></TABLE>

I would look into the engine mounts.

My '92 Civic (years ago) had the exact same issues as you describe. I couldn't find anything wrong with the engine mounts. Turned out to be the clutch slave cylinder. It's a relatively inexpensive part and easy to install.

Frickr

start with the easiest to check. mine does it it some time when im getting on it shifting into 2nd will not go in due to a toren tq mt

devin_hoang

toren tq mt?

Frickr

the lower left mount. im on my tablet so i got to write everything out

devin_hoang

what did you do to the mount to fix the problem.

Frickr

are the mounts good? if not jack up the motor and replace them