Compression question
02-14-2005, 02:04 PM
#1
Honda-Tech Member
Thread Starter
Join Date: Mar 2003
Location: Edmonton, AB
Posts: 592
Likes: 0
Received 0 Likes
on
0 Posts
Compression question
Hey i just did a compression test on my motor, and got 150-150-150-150... The numbers are dead consistent.
Is this alright? The car has about 30 000 miles on it and heard that you gain compression after time becuase of carbon buildup?
Is this alright? The car has about 30 000 miles on it and heard that you gain compression after time becuase of carbon buildup?
02-14-2005, 02:07 PM
#3
Re: Compression question (0097ITR)
On one hand they seem low, but on the other they are consistent and the low numbers were probably just because you could have used a few more "cranks" to up the numbers (and/or the throttle wasn't held open).
02-14-2005, 02:12 PM
#4
Honda-Tech Member
Re: Compression question (zygspeed)
As long as they are consistant, it should be ok. Some gauges don't read right, but 150 all across is nice.
P.S., I'll have a compression test treat for everyone in the next few days...
P.S., I'll have a compression test treat for everyone in the next few days...
02-14-2005, 03:41 PM
#5
Honda-Tech Member
Thread Starter
Join Date: Mar 2003
Location: Edmonton, AB
Posts: 592
Likes: 0
Received 0 Likes
on
0 Posts
Re: Compression question (drdisco69)
Ok i redid it again.
I let the engine warm up a bit longer, WOT, took off the intake, and i got 165 across the board. Maybe the piston rings arent fully seated yet. It burns no oil and runs great and fast, just wondering.
I am also using a "GRIP (grand rapids industrial products)" compression tester, maybe its too shitty to get a good reading.
I let the engine warm up a bit longer, WOT, took off the intake, and i got 165 across the board. Maybe the piston rings arent fully seated yet. It burns no oil and runs great and fast, just wondering.
I am also using a "GRIP (grand rapids industrial products)" compression tester, maybe its too shitty to get a good reading.
02-14-2005, 04:51 PM
#7
Honda-Tech Member
Thread Starter
Join Date: Mar 2003
Location: Edmonton, AB
Posts: 592
Likes: 0
Received 0 Likes
on
0 Posts
Re: Compression question (El Pollo Diablo)
enough, about 10 seconds according to helms..
The engine has one compression stroke every 4 cranks, so 8 cranks would be sufficient.(two compression strokes)
The engine has one compression stroke every 4 cranks, so 8 cranks would be sufficient.(two compression strokes)
Trending Topics
02-14-2005, 06:58 PM
#8
Senior Member
Join Date: Aug 2001
Location: USA
Posts: 18,261
Likes: 0
Received 0 Likes
on
0 Posts
02-14-2005, 10:56 PM
#10
Honda-Tech Member
Join Date: Nov 2004
Location: Canada
Posts: 922
Likes: 0
Received 0 Likes
on
0 Posts
Re: Compression question (0097ITR)
Good info here i think, got this from user "Nameless RB26" 
There isn't a 'there'. If numbers are consistent, then that's all that matters.
All low consistent numbers = bad gauge, good engine.
All high consistend numbers = good gauge, good engine.
All low inconsistent numbers = bad.
All high inconsistent numbers = bad.
That's the *general* rule I use when doing comp tests.
When it comes to actually DIAGNOSIS after a compression test.. you do a cylinder leak down.
Compression tests are not always acurate. They do not tell you what is wrong with your engine. They do nothing but give you a general *IDEA* of good/bad or ok.
When you do a compression test the engine MUST be at operating temp. Not warm. Not cold. You do it immediately following shutoff.
Throttle open.
All plugs removed.
6 or 8 cranks on each cylinder. Not 6 here, 8 there. The same on each cylinder.
Dry compression tests are worthless and usually innacurate.
I hope this info reaches people in searches.. because this topic has high frequency here.
There isn't a 'there'. If numbers are consistent, then that's all that matters.
All low consistent numbers = bad gauge, good engine.
All high consistend numbers = good gauge, good engine.
All low inconsistent numbers = bad.
All high inconsistent numbers = bad.
That's the *general* rule I use when doing comp tests.
When it comes to actually DIAGNOSIS after a compression test.. you do a cylinder leak down.
Compression tests are not always acurate. They do not tell you what is wrong with your engine. They do nothing but give you a general *IDEA* of good/bad or ok.
When you do a compression test the engine MUST be at operating temp. Not warm. Not cold. You do it immediately following shutoff.
Throttle open.
All plugs removed.
6 or 8 cranks on each cylinder. Not 6 here, 8 there. The same on each cylinder.
Dry compression tests are worthless and usually innacurate.
I hope this info reaches people in searches.. because this topic has high frequency here.
02-15-2005, 02:37 AM
#11
Honda-Tech Member
Join Date: Oct 2003
Location: Homie dont, play that, USA
Posts: 11,340
Likes: 0
Received 1 Like
on
1 Post
Re: Compression question (jBj)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by jBj »</TD></TR><TR><TD CLASS="quote">Good info here i think, got this from user "Nameless RB26"
There isn't a 'there'. If numbers are consistent, then that's all that matters.
All low consistent numbers = bad gauge, good engine.
All high consistend numbers = good gauge, good engine.
All low inconsistent numbers = bad.
All high inconsistent numbers = bad.
That's the *general* rule I use when doing comp tests.
When it comes to actually DIAGNOSIS after a compression test.. you do a cylinder leak down.
Compression tests are not always acurate. They do not tell you what is wrong with your engine. They do nothing but give you a general *IDEA* of good/bad or ok.
When you do a compression test the engine MUST be at operating temp. Not warm. Not cold. You do it immediately following shutoff.
Throttle open.
All plugs removed.
6 or 8 cranks on each cylinder. Not 6 here, 8 there. The same on each cylinder.
Dry compression tests are worthless and usually innacurate.
I hope this info reaches people in searches.. because this topic has high frequency here.
</TD></TR></TABLE>
Nice lil write up....
There isn't a 'there'. If numbers are consistent, then that's all that matters.
All low consistent numbers = bad gauge, good engine.
All high consistend numbers = good gauge, good engine.
All low inconsistent numbers = bad.
All high inconsistent numbers = bad.
That's the *general* rule I use when doing comp tests.
When it comes to actually DIAGNOSIS after a compression test.. you do a cylinder leak down.
Compression tests are not always acurate. They do not tell you what is wrong with your engine. They do nothing but give you a general *IDEA* of good/bad or ok.
When you do a compression test the engine MUST be at operating temp. Not warm. Not cold. You do it immediately following shutoff.
Throttle open.
All plugs removed.
6 or 8 cranks on each cylinder. Not 6 here, 8 there. The same on each cylinder.
Dry compression tests are worthless and usually innacurate.
I hope this info reaches people in searches.. because this topic has high frequency here.
</TD></TR></TABLE>
Nice lil write up....
02-17-2005, 11:32 AM
#12
Honda-Tech Member
Thread Starter
Join Date: Mar 2003
Location: Edmonton, AB
Posts: 592
Likes: 0
Received 0 Likes
on
0 Posts
Re: Compression question (Jon D)
Note, DO NOT use a shitty compressin tester. We redid the test with a good tester and got consistent 190's.
02-17-2005, 01:34 PM
#13
Honda-Tech Member
Re: Compression question (Blazeone)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Blazeone »</TD></TR><TR><TD CLASS="quote">consistent 190's. </TD></TR></TABLE>
What motor is this? Cams, compression, etc?
What motor is this? Cams, compression, etc?
02-17-2005, 03:18 PM
#14
Member
Join Date: Jun 2004
Location: Somewhere in MD, MD, USA
Posts: 4,558
Likes: 0
Received 0 Likes
on
0 Posts
Re: Compression question (Blazeone)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Blazeone »</TD></TR><TR><TD CLASS="quote">Note, DO NOT use a shitty compressin tester. We redid the test with a good tester and got consistent 190's. </TD></TR></TABLE>
thats more like it.
thats more like it.
Thread
Thread Starter
Forum
Replies
Last Post
Hondizzle!
Honda Civic / Del Sol (1992 - 2000)
9
09-13-2005 09:13 AM
Nisif
All Motor / Naturally Aspirated
3
04-12-2005 09:13 AM