No_jdm_fanboys

Hey guys recently got in a little bender lower rad support on the passenger side had to be bent back Into place. Got a new rad and installed refilled and burped the system now whenever I drive around and use the fans,blinkers or sunroof the needle on the temp only begins to climb to hot if everything is off works fine any known fixes or threads out there with similar issues??

Been looking around and all I can find is t stat malfunctions t stat is less then 6 no old fans do come on though and during. Normal even smashing a little temp does not climb (used the hwy to bring rpms up a little never pas 4.5k)

fcm

When one electrical load, [temp. gauge in your case] is effected by other loads, [any car electronics in your case] the problem is most likely a grounding issue.

The one thing that is common to all electronics is the grounds, [common ground]. 94

wunfstgsr

Yea its probably the trans ground check it!

No_jdm_fanboys

Hey thanks guys for the good info will check those and report back

No_jdm_fanboys

Grounds are all good burped it again with the bleeder valve and after sitting all night go to drive and it doesn't over heat anymore