ldyer1994

Hi all, so I just purchased a transmission, and found that the input shaft bearing was broken. It's only the outside part that's pressed in that's left. There's no room around the bearing, so there's nowhere to gain leverage. Any ideas on how to remove this?

B_Swapped93

So just the outer race? there's a little indent you can get a screw driver in to pry it out. It should just pry out you removed the main shaft and all that right? or are you taking someone's word on it.

tony_2018

So there is a tool that hooks onto the inner part of the bearing, tighten it and yank up.


Follow this guide that I found just by googling.

DIY: Transmission Rebuild (89pics!)