http://www.aj-racing.com/project-AJRDC2.html

It is a JDM ITR block bored and resleeved to 2000cc, fullt built bottom end (forged high compression pistons, 12:1), I am doing a rebuild on the engine in the next couple weeks before I sell it, so it will be pretty much a new engine.
The valve train consists of JUN stage 3 cams, toda valve springs, toda cam gears, and whatever is on that mod list on the link above (I am just listing all the important stuff). And a spoon valve cover.
Tranny is a ITR tranny with ATS 1st and 2nd gear (I could throw in the ATS 3rd, 4th, and 5th gearset as well, but that will cost extra), Spoon 1.5way LSD (low kms), and Spoon synchros.

There are also other things with the engine that I will be selling with this engine, seperate from this deal, such as a Hondata S200, BuddyClud Racing Spec computer, and a month old Spoon Sports 4-2-1 header, T1R full catback exhaust system, and a T1R cat.

PLEASE NOTE THAT THE INDIVIDUAL THROTTLEBODIES THAT WERE IN THE PIC DOES NOT COME WITH THE DEAL, THAT'S JUST THE BEST PICTURE I HAVE OF THE ENGINE. The engine I am selling will come with a stock ITR intake manifold, with a big bore throttlebody (70mm tapered on the outside, on the inside, after the butterfly plate is also taper bored to 64mm)

I am asking $9000 for the engine/tranny combo. Serious buyers only
if interested, please email me at moopuppet@hotmail.com
and for those who are going to be emailing me about "why are you selling, I have new plans for my car, that's all I can say right now "

I am located in BC, Canada. I would prefer local deals only, but if you would like to have everything shipped (US only), buyer would have to pay for shipping.

*also if you have anything negative to say about the setup, price, or anything. Or any comments that does not have anything to do with the deal, pleaes keep them to youself , thanks*

 

are the individuals still available????

 

where can u get spoon synchros i would love to know

 

The synchros just came with the tranny I got off Ben (owner of AJR), it used to be on his old EK hatch, and he got them from Spoon Sports himself.

and sorry, the individual throttlebodies are already sold.

 

the asking price is in CAD btw!
my bad for not stating that earlier.

 

ttt

 

u sell the block seperate?

 

sorry I'll be selling it as a whole.

 

good god

 

bump for one of the sickest motors i have seen

 

PM'd u

 

what kind of whp/torque numbers was it putting out?

now i have to contemplate b18c5 again, or k20a2

 

With my previous setup (toda b cams, I now have JUN 3's in), I had it dyno at 226whp and 140ish tq (don't remember exactly )
and since then I have changed cams, and will be a fresh motor (rebuild), and hondata (before I tuned it with BuddyClub Racing Spec Computer)