I know it's been covered throughout the forum, but I though I'd refer to this again. Hopefully this will help those who are removing their pulley.
Tools used:
50mm Hex Honda Crank Pulley Tool
Jack Stand
17mm 1/2" drive socket
2 Extensions
1/2" Breaker Bar
2 Pipes, 1 to fit over Pulley Tool, and 1 extra long one for the breaker bar(not shown).
Note: If you don't have the pulley handle like me, then you would need a pipe big enough to go over the pulley tool. If one has the handle, then only one long pipe is needed.

 

wtf..u make that so difficult i do it with a deepwell 17mm socket and a walmart breaker bar. u remove the flywheel cover and stick a screwdriver to wedge the flywheel.

 

i must not have lodged the screwdriver in well in my case. this seem to work the best for me. many others have done it this way too!

 

jump on breaker bar!