Ok, i currently have a chrome valve cover(non v-tec; rs) and the problem is it does not have the hole in it for the pcv valve(middle red below). So the setup i had was just breathers on intake mani, intake, and nipple on the valve cover(right red below).

After extensive reading i figured it was best to hook it back up because oil was coming out of the valve cover. I had to do it custom, so tell me if anything is wrong with what I did...

 

now im thinking should i of even hooked it to the intake??

 

bump

 

bump

 

its not perfect, you may have a vacuum leak, since the air can just bypass the throttle body, generally its suppost to be a 1 way system, intake to vc, vc to mani, but this is asking 1 tube to go both ways.

dont quote me on any of this though, run it, and if it works then no harm no foul, i think the worst thatll happen is you may have a small vacuum leak, or you may get a little oil in your intake.

 

is oil going through the throttle body bad? thanks for input

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by lmike6453 &raquo;</TD></TR><TR><TD CLASS="quote">is oil going through the throttle body bad? thanks for input</TD></TR></TABLE>

It won't be good after it lumps up over time

 

so any suggestions about modding this?

 

bump

 

i think your missing an intake runner on your intake there. i just put a breather on the valve cover and one on the intake...

 

haha...i was thinking some more and was wondering will oil even go through the intake because the line that goes from pcv valve to intake manifold is a vacuum line

 

bump

 

ok i disconnected the one line to the intake...is that ok? just going from the valve cover to intake manifold..