I need help installing my avcr. i have the electrical connections taken care of, i just need help with the 2 sensors that you mount in the engine bay and the vacuum lines. any help would be appreciated.

 

sorry, i have a jdm b16 in a 92 hatch with a greddy 18g turbo kit.

 

bump

 

What help do you need? One is a pressure sensor (the only one with 1 vacuum inlet), and the other squarish thing with the 2 vacuum nozzles is the solenoid.

 

Plug the yellow wire end into the yellow connector
-repeat for white and red wires
--repeat at the TV with other end of wires
plug the two bladed one prong connector into the socket on the wall with two slots and a hole
finally connect the threaded plug with a sharp thing in the middle onto the threaded plug with a small hole in the middle and tighten.
-repeat with other end of wire at the wall.

-Dustin

 

go on the apexi web site and look at the manual if you dont already have one. http://www.apexi-usa.com/productdocu..._savcr_ins.pdf look on page 42 i think

 

??

 

I have the instructions, I just dont undertsand them. i just want someone to tell me what vacuum lines go to/from the circular sensor thingy and what lines go to/from the box thingy

 

You run 1 vacuum line from the round pressure sensor to any boost source (most people choose the FPR vacuum line). Then you run one vaccum line to the 'IN' port on the solenoid, and another vacuum line from the 'OUT' port to your wastegate actuator.

 

very helpful, and thats it>? thank you so much!