Just got back from the machine shop!!!!
Thread Starter
New User
Joined: Apr 2001
Posts: 786
Likes: 0
From: NJ
Just got back from the machine shop!!!!
Clean block only.............................................. ........................$60
Bore & power hone block for customer supplied pistons...............$200
Balance complete engine assembly (internal/external).................$200
File fit rings to bore.............................................. .....................$65
Remove galley ***** for service from crank, drill & install set
screws, clean, mike & polish crank (HP4)....................................$230
Machine flywheel (step)............................................ .................$75
I just had all this service done to my parts. I'm installing Eagle rods, JE Pistons (81.5 mm), RC 440's and a V-AFC. Any opinions, hints or tips???
Bore & power hone block for customer supplied pistons...............$200
Balance complete engine assembly (internal/external).................$200
File fit rings to bore.............................................. .....................$65
Remove galley ***** for service from crank, drill & install set
screws, clean, mike & polish crank (HP4)....................................$230
Machine flywheel (step)............................................ .................$75
I just had all this service done to my parts. I'm installing Eagle rods, JE Pistons (81.5 mm), RC 440's and a V-AFC. Any opinions, hints or tips???
D Tranny Guru
Joined: Oct 2001
Posts: 8,725
Likes: 8
From: Cincity, OH, USA
Re: Just got back from the machine shop!!!! (GSRacer)
Machine flywheel (step)........................$75
If it was lightened it will need to be balanced again.
Thread
Thread Starter
Forum
Replies
Last Post
Golden Eagle
Southern California (Sales)
33
Oct 20, 2011 01:47 PM
baphomet
Forced Induction
10
Feb 2, 2003 09:25 AM