Honda-Tech - Honda Forum Discussion
0 2016/12/30 02:17:25
0 2016/12/30 02:17:07
Found a twin! Followed him to his destination then talk cars.
Found a twin! Followed him to his destination then talk cars.
0 2016/12/30 02:16:28
Cut the fenders out for OEM side markers..scary. Placement isnt right. F it.
Cut the fenders out for OEM side markers..scary. Placement isnt right. F it.
0 2016/12/30 02:15:31
Installed the spoiler.
Installed the spoiler.
0 2016/12/30 02:14:45
0 2016/04/30 10:52:53
0 2016/04/30 10:41:23
0 2016/04/30 10:40:45
0 2016/04/30 10:40:11
0 2016/04/30 10:39:35
0 2016/04/30 10:38:57
0 2016/04/30 10:38:36
0 2016/04/30 10:38:32
Yep, pin 2, white/red of the green connector. needs to go to a23. :)
Yep, pin 2, white/red of the green connector. needs to go to a23. :)
0 2016/04/06 18:11:55
0 2016/04/06 16:45:25
Believed to be a 99-00 d16y7 manual ECU.
Believed to be a 99-00 d16y7 manual ECU.
0 2016/04/06 15:54:48
Pins are different from c131 to ECU connector pins.
Pins are different from c131 to ECU connector pins.
0 2016/03/04 21:20:03
0 2016/03/04 19:54:20
0 2016/03/04 18:37:45
0 2016/03/04 17:21:33
0 2016/03/04 16:11:43
0 2016/03/04 14:13:58
My secondary o2 plug and it's wire colors.
My secondary o2 plug and it's wire colors.
0 2016/03/04 14:12:57
Step one- complete. Headed home for testing. Have to figure out where to set the dial.
Step one- complete. Headed home for testing. Have to figure out where to set the dial.
0 2016/03/04 13:26:49
Plan to clear the haze on the headlight. Threw the fender on until I feel like having it painted. Mocked up the bumper bra. Need passenger fender for it to look good..and need one in general lol.
Plan to clear the haze on the headlight. Threw the fender on until I feel like having it painted. Mocked up the bumper bra. Need passenger fender for it to look good..and need one in general lol.
0 2016/02/24 18:30:50
Here's the old driver crap headlight. Deer did this. All tabs broken and cracked case.
Here's the old driver crap headlight. Deer did this. All tabs broken and cracked case.
0 2016/02/24 18:30:16
Replaced cap, rotor, fuel filter and plugs. Did the wires recently.
Replaced cap, rotor, fuel filter and plugs. Did the wires recently.
0 2016/02/24 18:29:07
0 2016/02/23 17:59:30
Poor pic.
Poor pic.
0 2016/02/23 17:56:58
0 2016/02/23 17:54:02
It's going in!
It's going in!
0 2016/02/21 02:08:44
Got the good used knuckles from my parts car. I'll probably keep the old ones, put new hubs, rotors bearings, lug studs and lower ball joints on them so I have a set ready to throw on. At that time I'll probably want to do axles, inner/outer tie rods, bellows boot and upper ball joint.... All that would be so sweet and expensive.
Got the good used knuckles from my parts car. I'll probably keep the old ones, put new hubs, rotors bearings, lug studs and lower ball joints on them so I have a set ready to throw on. At that time I'll probably want to do axles, inner/outer tie rods, bellows boot and upper ball joint.... All that would be so sweet and expensive.
0 2016/02/21 02:08:11
0 2016/02/19 17:12:41
Hole.
Hole.
0 2016/02/19 17:12:35
Removed old transmission and installed a supposed OEM rebuilt LSD transmission. Supposed to have 0 miles. Picked it up a few months back from a friend for 200.
Removed old transmission and installed a supposed OEM rebuilt LSD transmission. Supposed to have 0 miles. Picked it up a few months back from a friend for 200.
0 2016/02/19 17:12:29
0 2016/02/19 17:12:16
And it's out!
And it's out!
0 2016/02/19 17:10:23
Last drive with its original motor.
Last drive with its original motor.
0 2016/02/19 17:10:14
How it died. Original motor and transmission.
How it died. Original motor and transmission.
0 2016/02/18 19:08:07
Dirty dirty bay.. Sat for 2 years. Hose is off. :( might take a bucket and a rag to it.
Dirty dirty bay.. Sat for 2 years. Hose is off. :( might take a bucket and a rag to it.
0 2016/02/18 19:08:03