Honda-Tech - Honda Forum Discussion
Took out the climate control module in order to zap strap the temperature cable sleeve. The original plastic holding it in place had gotten brittle and broken off. This is the underside. I disconnected the harnesses further down in the centre console, rather than at the climate control module, so that I didn't have to take off the dash bezel and disconnect from the back.
Took out the climate control module in order to zap strap the temperature cable sleeve. The original plastic holding it in place had gotten brittle and broken off. This is the underside. I disconnected the harnesses further down in the centre console, rather than at the climate control module, so that I didn't have to take off the dash bezel and disconnect from the back.
0 2022/06/18 16:10:44
The old rear engine mount
The old rear engine mount
0 2022/06/26 09:24:09
Nakamishi
Nakamishi
0 2023/03/12 19:17:49
In the dark
In the dark
0 2023/03/12 19:18:32
Resonator pipe pushed back 1 1/2"
Resonator pipe pushed back 1 1/2"
0 2023/08/14 16:53:08
S-pipe pushed back 1 1/2", against the back of the heat shield
S-pipe pushed back 1 1/2", against the back of the heat shield
0 2023/08/14 16:53:27
0 2023/08/14 16:53:40
0 2023/08/14 16:55:37
0 2023/08/14 16:55:41
0 2023/08/14 16:55:44
Resonator pipe pushed back 1 1/2"
Resonator pipe pushed back 1 1/2"
0 2023/08/14 16:56:13
S-pipe pushed against the heat shield
S-pipe pushed against the heat shield
0 2023/08/14 16:56:16
0 2023/08/14 16:57:28
0 2023/08/16 07:57:56
kms not miles, but still...
kms not miles, but still...
0 2023/12/02 16:07:01
3M structural adhesive, RH rear quarter panel, and 2-part epoxy squeeze gun
3M structural adhesive, RH rear quarter panel, and 2-part epoxy squeeze gun
0 2024/04/21 17:30:30
0 2024/04/21 17:35:00
0 2024/04/21 17:35:07
0 2024/04/21 17:35:16
0 2024/04/21 17:35:22
0 2024/04/21 17:35:28
upper left solder joint in the speedometer section (middle), re-flowed
upper left solder joint in the speedometer section (middle), re-flowed
0 2024/07/07 18:05:28
Gauge cluster separated
Gauge cluster separated
0 2024/07/07 18:11:51
Speedometer removed
Speedometer removed
0 2024/07/07 18:12:00
Speedometer board removed
Speedometer board removed
0 2024/07/07 18:12:06
Brown marks on top of the old capacitors, but the tops are not split open
Brown marks on top of the old capacitors, but the tops are not split open
0 2024/07/07 18:12:13
New capacitors
New capacitors
0 2024/07/07 18:12:20
Old (brown) capacitors out, 1 new capacitor soldered in
Old (brown) capacitors out, 1 new capacitor soldered in
0 2024/07/07 18:12:26
Don! plug in place and about to fill the overflow bottle
Don! plug in place and about to fill the overflow bottle
0 2024/07/11 18:25:12
Old timing belt
Old timing belt
0 2024/08/18 20:31:33
Needed 2 breaker bars and the crank pulley tool to loosen the crank pulley bolt
Needed 2 breaker bars and the crank pulley tool to loosen the crank pulley bolt
0 2024/08/18 20:32:35
The old NPW water pump has 3 dowels, the bew Honda one doesn't have them
The old NPW water pump has 3 dowels, the bew Honda one doesn't have them
0 2024/08/18 20:34:22
Scotch brite got the old gasket material off the mating surface
Scotch brite got the old gasket material off the mating surface
0 2024/08/18 20:36:32
Engine supported from below, motor mount off to remove the old timing belt
Engine supported from below, motor mount off to remove the old timing belt
0 2024/08/28 22:18:36
Old timing belt and new OEM timing belt still in the package
Old timing belt and new OEM timing belt still in the package
0 2024/08/28 22:19:57
Checked the sizes and the number of teeth, they matched up
Checked the sizes and the number of teeth, they matched up
0 2024/08/28 22:21:00
0 2024/08/28 22:22:01
New timing belt is in
New timing belt is in
0 2024/08/28 22:23:25
Cams out, assembly lube brushed on
Cams out, assembly lube brushed on
0 2024/11/12 19:39:22
Middle 3 cam holders are on
Middle 3 cam holders are on
0 2024/11/12 19:40:26