I bent my radiator support and I have a replacement on the side. How hard is it to take off the old one and weld the new one back on? Any recommendations my friend is going to try help me do it this weekend.

 

Not hard, just get a spot weld remover drill bit and go to down anywhere you see spot welds. Make sure the rest of the unibody is straight, then simply weld the new one in place.

 

HybridKOOP

Re: Radiator Support (GSR_96814) 11:22 AM 3/2/2006

--------------------------------------------------------------------------------

Not hard, just get a spot weld remover drill bit and go to down anywhere you see spot welds. Make sure the rest of the unibody is straight, then simply weld the new one in place.

how exactly do you do that?

 

I'm assuming you have a GSR. Same **** happened to me. You should buy a spot weld bit off ebay for like $25 shipped. I couldnt find one anywhere else. A drill bit for metal will take you all day. This shows you exactly where the spot welds that need to be drilled out are. Good luck https://honda-tech.com/zerothread?id=1346217