B16 trans with ctr LSD problem?
09-05-2013, 08:18 PM
#1
Honda-Tech Member
Thread Starter
iTrader: (4)
Join Date: Jan 2012
Posts: 398
Likes: 0
Received 0 Likes
on
0 Posts
B16 trans with ctr LSD problem?
Just bought a b16 trans with ctr LSD. Is the diff suposse to move side to side?? If you put your hand on one side of the diff and your other hand on the other side you can move it back and forth. Is this normal?!
09-09-2013, 09:55 AM
#6
Join Date: Feb 2004
Location: San Dimas, CA
Posts: 5,857
Likes: 0
Received 0 Likes
on
0 Posts
Re: B16 trans with ctr LSD problem?
They may have installed the incorrect bearings on the LSD and/or not have set the preload correctly.
Get it open and check what bearings have been installed and what shim was used. If it was installed using B16 bearings..here is what you will need to fix it:
It will need two offset bearings for ITR/CTR/Late model GSR differentials:
http://shop.synchrotech-transmission...GSR-B-ITRB.htm
or you can also use a Conversion kit to save some $$:
http://shop.synchrotech-transmission...-GSR-BITRC.htm
The difference between a B16 diff bearing and ITR/CTR/Late model GSR diff bearing is a 1mm offset on the center inner diameter where it mounts onto the bearing spigot.
Get it open and check what bearings have been installed and what shim was used. If it was installed using B16 bearings..here is what you will need to fix it:
It will need two offset bearings for ITR/CTR/Late model GSR differentials:
http://shop.synchrotech-transmission...GSR-B-ITRB.htm
or you can also use a Conversion kit to save some $$:
http://shop.synchrotech-transmission...-GSR-BITRC.htm
The difference between a B16 diff bearing and ITR/CTR/Late model GSR diff bearing is a 1mm offset on the center inner diameter where it mounts onto the bearing spigot.
Thread
Thread Starter
Forum
Replies
Last Post
