valve cover cutting
Thread Starter
Honda-Tech Member
Joined: Dec 2001
Posts: 627
Likes: 0
From: Altadena, CA, USA
valve cover cutting
Ive seen posts on this before but Im wondering how you would cut your valve cover and timing belt cover like this?
[Modified by erniecars, 6:48 AM 3/11/2002]
[Modified by erniecars, 6:48 AM 3/11/2002]
Honda-Tech Member
Joined: Jul 2001
Posts: 1,510
Likes: 0
From: Bellingham, WA, USA
Re: valve cover cutting (dirtySOHC's)
I would imagine a holesaw would do the trick.
I cut mine off entirely though, http://www.fatboyraceworks.com/crx/i...e/DSCF0068.jpg
you can actually see the piece still laying on the floor below the engine.
I cut mine off entirely though, http://www.fatboyraceworks.com/crx/i...e/DSCF0068.jpg
you can actually see the piece still laying on the floor below the engine.
Honda-Tech Member
Joined: May 2001
Posts: 245
Likes: 0
From: Trabuco Canyon, CA, USA
Re: valve cover cutting (erniecars)
well you can cuz it by clamping the two togeather and useing a hole saw, or you can draw a half circle pattern on the two and cuz away the material with a die-grinder
Junior Member
Joined: Jul 2001
Posts: 817
Likes: 0
From: Los Angeles, ca
Re: valve cover cutting (erniecars)
go check out : http://www.pmpdesigns.com i think they charge like only $40 if you have the valve cover already...........
Thread
Thread Starter
Forum
Replies
Last Post
toshiyuki
Acura RSX DC5 & Honda Civic EP3
3
Apr 21, 2017 08:38 PM
