anyone good wit a trans, they know what they are doing? i need the shaft replaced that hooks to the shift linkage it was bent on the highway by some junk in the road from the construction workers this is a gsr tran that was just rebuild so the gears are good that shaft is bent so it dont fully engage in 2nd 4th and rev

help

got money in hand

 

somebody know how to rebuild transmissions

 

u just need your shift rod replaced right?? I doubt it would be the transmission itself. U should be able to do it yourself.

 

yea just the shift rod needs to be replaced but all the gears need to be out to get to it

 

I cant see what you are looking at so I can not say for sure but... I highly doubt you damaged the inner portion of that tranny piece. probably just need to replace the piece from the tranny to your shifter. There's a rubber boot where the shift rod has a clip to expose the spring pin that you remove. I am assuming that you know this though. Just wanted to clarify that you need actually need tranny work.

 

the piece the shift linkage hooks to, the little rod coming out of the trans is bent the shift linking is bolted to the trans wit a 12mm bolt and then it has a pin that needs to be banged out the piece that the pin goes in is bent that needs to be replaced

 

crazy. looking at the stub that comes out the tranny. hard to believe it can be bent like that. Good luck finding someone to help you out. I am sure lots of people here can help with ideas and tech stuff... they have for me... but hands on in your area.