Hello guys!
I'm new to this forum, and would be great if I could get some help with my problem.

So I did over-rev my B20 (in a Civic 97 Hatchback) and now I have no speed in my cluster. I have RPM and all other gages working fine. I tought, maybe the chipped ECU did detect something and went in some mode, but after I restart the car same problem. It did throw a code after about 5 minutes, but when I restarted the code was not there anymore but I had the same problem with the speedo. Maybe the speed sensor ? If anyone could tell me too where its located, cause I have no idea.

My launch control is @ 4500rpm, so I can't get past 4500rpm or launch control goes on. (Launch control is @ 0 speed, ECU detect im not rolling but only revving... -.- xD) Beside that car is rolling.

Just registered, used the search but didn't find anything much related to it, and hope my thread is comprehensible, I'm french canadian (Quebec) :p

Thanks everyone! Hope I can get some help from the forum!

P.S: I went to a meet so I quickly brake cleaned and hosed some spots with water. Very gently and barely got any wires with water, but I did get some and some had duct tape so i'll look into that.

Suck cause I was on highway and a guys pulled up to me with his b20 EK, and I couldn't follow -.-

 

VSS in the rear of the transmission