OK, heres the story. I purchased this IM brand new about 10 months ago. I finally got all the parts together to do my swap and did it last week. I worked out the major bugs, but now I noticed my IM has a major vaccum leak. It is coming from the big freeze plug on the end of it. I am going to call skunk2 tommorrow, but was wondering if anyone else had a problem like this. Its not a little leak where it will suck your finger to it, but it will suck your whole hand to it if you get close enough.

TIA for any input.


-Ace

 

did the plug fall right out? or is it just leaking?

could you possibly seal it with some epoxy or something?...........it would be a bitch to have to remove it again for a replacment...........thats if skunk2 will give you a new one...........

either way good luck with it.....

 

Honda bond it.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by non-VTEC &raquo;</TD></TR><TR><TD CLASS="quote">did the plug fall right out? or is it just leaking?

could you possibly seal it with some epoxy or something?...........it would be a bitch to have to remove it again for a replacment...........thats if skunk2 will give you a new one...........

either way good luck with it..... </TD></TR></TABLE>


It didnt come out, just pulling alot of vaccum. I dont mind taking it off if they will give me one that doesnt leak. I could fix it myself, but thats not the point...I shouldnt have to.


-Ace

 

Id call them up and tell them to give you a new one. I ve had mine since may with no problems. I cant remember if there is a waranty on them or not?

 

I talked to Skunk2 today. They told me if I want to send mine back they will replace it. If I cant afford the down time, I can purchase a new one from them and they will refund my money when they receive mine back. I think I'm going to end up going that route so I wont have as much down time.


-Ace