short ram vs DIY ice box
hey i have a short ram intake right now ..left over from the hatch. but im thinking are they any better or worse than the DIY ice box. if it is well hell ill put it back on
any dyno's on this or personal thoughts
any dyno's on this or personal thoughts
A DIY should be better, since you can route COLD air from outside into the intake, as opposed to the short ram, which is breathing underhood air, which should be quite warm (HOT).
I made a DIY using stock air cleaner box, heater hose ran outside the underhood compartment, no resonator (good riddance), and a K&N filter.
Ask on the integra forums too.
I made a DIY using stock air cleaner box, heater hose ran outside the underhood compartment, no resonator (good riddance), and a K&N filter.
Ask on the integra forums too.
The DIY "Icebox" will give you much better throttle response and the low to mid range power will also be better. I highly recommend the DIY "Icebox".
You can go to my webpage at http://www.geocities.com/bretq/DIY_Icebox_CAI.html for instructions on making your own "Icebox".
BTW, I also just started selling my Icetake CAI which will save you from having to find the material for making your own "Icebox". Go to http://www.geocities.com/bretq/icetake_cai.html for further information. You can also check out the classified forum at https://honda-tech.com/zerothread?id=140106
You can go to my webpage at http://www.geocities.com/bretq/DIY_Icebox_CAI.html for instructions on making your own "Icebox".
BTW, I also just started selling my Icetake CAI which will save you from having to find the material for making your own "Icebox". Go to http://www.geocities.com/bretq/icetake_cai.html for further information. You can also check out the classified forum at https://honda-tech.com/zerothread?id=140106
Thread
Thread Starter
Forum
Replies
Last Post




