Ring end gap questions
#1
Honda-Tech Member
Thread Starter
Ring end gap questions
I gapped my rings on a freshly bored and honed block .25 OB and found all the gaps were larger than the new limits but smaller than the service limits per Helms.
Should I really worry about it buring oil?
Should I really worry about it buring oil?
#3
Honda-Tech Member
Thread Starter
Re: Ring end gap questions (earl)
Thinking back, the gap specs didn't specify STD or OB in the Helms. DO I need to recalculate the end gap with an OB block? Like take the STD limits and add a certain amount to compensate for the larger bore or am I just thinking too hard as usual? :D
#5
Honda-Tech Member
Thread Starter
Re: Ring end gap questions (sgT)
Yes, factory rings on factory pistons. Both .25mOB in a freshly bored block. 81.25mm bore.
I was thinking the same thing on the rings needing to be messed with since the bore was fresh and all.
I was thinking the same thing on the rings needing to be messed with since the bore was fresh and all.
#6
Honda-Tech Member
Join Date: Jul 2002
Location: ORANGE COUNTY CALIFORNIA, US
Posts: 1,669
Likes: 0
Received 0 Likes
on
0 Posts
Re: Ring end gap questions (sgT)
Are these factory rings?
I have foundthat factory rings rarely need to have the gap adjusted.
I have foundthat factory rings rarely need to have the gap adjusted.
you don't have much of a choice
Thread
Thread Starter
Forum
Replies
Last Post