I had my block rebuilt and such, and when I got it back they told me everything was tuned and ready. So I get my motor broken in and then boom... detonation. not too much damage, I need a new endyn 9.1:1cr piston, and will have to resurface my head.(little chunks of my piston got pushed into my head). Does anyone know a good machine shop in socal that can do the work for me??? Also how does the new piston instal work? do I need new piston rings and have to re seat them, or can I use my old ones(only aprox 2500 miles on them)??? How much will the instal cost? sorry for all the questions. TIA

 

Go to Dynamic Autosports and ask for Omniman.

You can't get too much betther than him.

 

alright awesome, they are located about 5 minutes from my house

 

anyone else?

 

how much does resurfacing generally cost??

 

depends how much is milled. for 0.005 light resurface it's around $25-35.

 

here is the head, you can see the piston peices that got hit on the head

 

Not sure how deep your piston pieces are stuck on the deck surface.

JG can weld repair it if need be.

 

jg??

 

JGEngineDynamics

http://www.JGEngineDynamics.com