I have some LS rods with some forged SRP pistons on them. Would you suggest that i take them to a shop to remove the pins and about how much would they charg?

 

take it to someone that has the right tools to do that. Machine shops should be able to handle it.

 

There are special tools to press off wrist pins that the Honda Dealer has however any competent machine shop should be able to perform this task with ease.

Pressed pins require the correct tools to remove and install and some machine shops use rod heaters to expand the small end of the rod to help the pin come out.

 

if you are good at this sort of thing, id bet you can do it with some needle nose pliers, small flathead screwdriver, a vice, wrist pin sized socket and rubber mallot and perhaps a hand torch.


or you can have a machinist do it for like 40 bucks