Hey guys I have a B16 and I'm getting CTR pistons tonight. I know they have to be modified to accomodate the B16 rod. My question is, how hard is this? They will be going to a machine shop. How much should it cost? Also, can I run into problems with only CTR pistons in my stock B16? What kind of gains can I expect?

Thanks a lot!

Goldfingiz

 

Anyone? The rings say P13 rather than PCT. Is that right?

Thanks,

Nick

 

I am starting to regret the purchase. I hope the machine shop can do this without costing an arm and leg. =\

 

why are you regretting it? i was considering doin the same...

 

I'm just hoping my machine shop can get the pistons on the rods. Also, I'm hoping it wont cost too much, and I'm concerned the piston is too wide for the cylinder. Am I going to have to bore it out?