i would like to know if anyone inthe phila. area might be able to help me degree my cams. i hope its not asking to much. for full details pm me or post and i will go throuigh my whole story.

i am going to run a set of S2S2 camswith .5mm over valves. i need to do a complete measurement of all clearances. i am comfortable about tdoing that by the way. just thought i would see if anyone might wantt o chip in on my fully built H22

 

/\/\

 

come on fellas, ttt

 

NOBODY CAN HELP OUT HUH, NO ONE DEGREES CAMS ON HERE? WTF

 

I do, and I know Greg Samaroo does, but neither of us are in the Philly area.

 

cool, nice to see someone can do it. thanks ofr letting me now that not everyone is dumb