machine work questions
Thread Starter
Junior Member
Joined: Jun 2005
Posts: 55
Likes: 0
From: USA
machine work questions
Im going to do a set of pistons and rods in a b18c. This is going to be a turbo build aiming for 9:1cr. Looking for around 450whp on stock sleeves with a good tune. Also gonna have a block guard installed. Is bore/hone and polish crank enough or does the block need to be decked too??
Mad Scientist
Joined: Nov 2002
Posts: 5,827
Likes: 1
From: tallafizzy, FL state
Re: machine work questions (rrmorseb18c)
the block will need to be decked if straightness is out of spec.
If its imperative for you to use a block guard make sure they bore/hone with it on.
If its imperative for you to use a block guard make sure they bore/hone with it on.
Thread
Thread Starter
Forum
Replies
Last Post
vtechjunkie
Honda Civic / Del Sol (1992 - 2000)
7
May 10, 2009 02:49 PM
phiberoptik
Forced Induction
2
Oct 29, 2003 11:58 AM