lug stud
Thread Starter
Honda-Tech Member
iTrader: (1)
Joined: Feb 2003
Posts: 3,923
Likes: 0
From: somewhere in..., pa, usa
lug stud
i friend was tightening my lug nuts with an impact and the studs broke, so i was wondering if anybody could give me a how to on doing this or is it reccommended to just take it to a shop?i heard you need new bearings and all kindsa fun stuff
Honda-Tech Member
Joined: Jan 2003
Posts: 8,132
Likes: 5
Re: lug stud (ebpG2)
I don't have a '91 and I don't know whether you're talking about front or back.
On my '95 GS-R the front ones don't have any clearance to push out. So you have to press the hub out of the wheel bearing. This USUALLY destroys the bearing, so you need another one.
I believe you can take the rear hub off without destroying the bearings?
Then you press the stud out & press a new one in.
On my '95 GS-R the front ones don't have any clearance to push out. So you have to press the hub out of the wheel bearing. This USUALLY destroys the bearing, so you need another one.
I believe you can take the rear hub off without destroying the bearings?
Then you press the stud out & press a new one in.
Thread
Thread Starter
Forum
Replies
Last Post
FRKWOO
Honda Civic / Del Sol (1992 - 2000)
1
Mar 18, 2010 10:43 PM
Nova_Dust
Honda Civic / Del Sol (1992 - 2000)
7
Jan 17, 2005 06:36 AM