Hey im going back and fore i was thinking about b18c5 in a ls 90-93 yet but i need 92-93 for b18c5 but can i do ls vtec with a c5 head or defines the whole point of the ls vtec?thanks in adavance


Gsr head is what b?


Modified by CrxStreetRacer at 8:20 PM 6/24/2004

 

Your post is a little hard to understand but ill try to help.You can use a type r head on an ls/vtec.Why would you need a 92-93 to use a type r head?The gsr is a b18c1.An ls vtec is any integra LS block from any 90-2001 non vtec integra with any dohc vtec b series head(b16a,b18c etc)

 

oh sry you cant understand me but i can use an itr head on a b18b1 block?

 

bump for the nite!

 

Do you know whats involved in doing an lsvtec? It's not just bolting a vtec head to a non-vtec block. Just understand that. Yes an ITR head will work.

 

ya i know their all kinds of stuff line fittings gaskets ya the whole nine yards

 

You will need a T fitting in place of the oil pressure sensor,the oil pressure sensor should screw into the end of the T.Than you need to run an oil feed line to the head.The line should be braided and i suggest -6an.There are other fittings/adaptors you need to get for the oil line to screw into the T and to screw into the head,but i do not remember the exact size,as i have all of that written down at the shop.You will also need to tap the original vtec oil supply hole on the bottom of the head,than screw a plug into that also.You will also need to relocate the dowel pins on the underside of the vtec head to the other side of the head.This only involves enlarging holes on the opposite side of the head to accept the dowels.

 

can u use an b16b i just thought about it?

 

 

damn cant you alteast say sumthing than dam face that means jack!

 

yea, you COULD....

research more first please.

 

Any B series VTEC head will work. By the way, B18C5, B17A, B16A (and maybe B, not sure) heads are the same casting (PR3).

 

thanks

 

i would also recommend a vtec oil/water pump.