There are two wires that come out of the IAB on my gsr motor. Do both of them plug into the ecu?

 

They came off the small plug right? If I remember correctly when I did my swap. One is go to 12 v power, the other is to the ECU.

 

I thought one went to a ground and one the ecu? But where should I ground it if thats the case? Or hook it to 12v power?

 

I'm pretty sure it's to 12 volt source when you turn on the car. Just find a source that have 12 volt when you turn the key. I hook it up to my stereo wiring that gives 12 volt when I turn the key. If i'm not mistaken, it's the yellow/black wire. Double check becuz it's been 1 year.

 

Can anyone confirm this?

 

yep. yellow/black to 12v, red/blue to a17. I spliced the yellow/black into the sensor lead wire which is in a25. hope this helps


Modified by nscivic at 5:21 AM 6/25/2003

 

Cool, This helps me alot!! I'm doing an h22a4 in my 92 prelude s, and needed the wiring for the iab. Thanks again!!!!