I have an eg civic hatch, i did a 5 stud conversion from a 98 JDM ITR, when i fitted it all i found the splines on the driveshaft were too small, so then i got some 00 ITR (unsure of DM) CV joints, upon fitting i then found out the nuts for the end of the shaft were too small. I went to honda today to get some new ones quoting a friends registration who owns a ITR (UKDM 5 stud), THE NUTS DONT FIT!!!!!!!

has the guy given me the wrong nuts, or is there a difference between JDM and UKDM CV shaft sizes?????

 

If they're '98-spec JDM ITR hubs, then you need the axle nuts from an '94 to '97 Accord.

 

yes!!!!

iv been everywhere today trying to find some taht fit
thanks again

 

will prelude ones fit?

 

I don't know. Give it a try. They'll probably also work since the hub type is similar to an Accord's of the same era.