How would you replace a TDC censor?
Thread Starter
Member
Joined: Feb 2003
Posts: 1,317
Likes: 0
From: Two blocks from the beach, CA, United States
How would you replace a TDC censor?
where is the TDC sensor inside the distributor? Also where exactly do i put the jumper wire on the harness to check stored engine codes?
Honda-Tech Member
Joined: Oct 2001
Posts: 4,611
Likes: 3
From: Severn, MD
Re: How would you replace a TDC censor? (ekhybrd)
If the TDC sensor is bad, replacing the sensor means replacing the entire distirbutor sub-assembly.
If you look up under the dash where the ECU is, there should be a green rubber plug which contains a blue 2-pin connector. Its this connector that you can use a paper clip to short out to check for engine codes.
If you look up under the dash where the ECU is, there should be a green rubber plug which contains a blue 2-pin connector. Its this connector that you can use a paper clip to short out to check for engine codes.
Thread
Thread Starter
Forum
Replies
Last Post
naderesb
Honda Accord (1990 - 2002)
11
Nov 20, 2022 02:36 AM
i_VTEC
Honda CRX / EF Civic (1988 - 1991)
17
Oct 15, 2007 10:17 AM
BRAWDY03
Tech / Misc
2
May 13, 2004 04:50 PM
