Whats the Highest compression i can run in my B18c1 on pump 92/93 octane?

 

Ive heard 11.4:1 but then again i see people running higher and i hear about these rollerwaves by Endyn???

 

people run that CR on pump 91 octane. You can probably run up to 12's with a problem. If youre unsure about it, you can always get yourself a J&S safeguard.


[Modified by Type Goch, 11:13 PM 11/6/2001]

 

I liked the idea of the CTR pistons but wasnt sure if id be able to on pump gas

 

i have 12.1 endyns...93 octane

 

CTR pistons with no probs. (and a milled head)...

 

Will i have to mill the head of my b18c1 to run those ctr pistons?

 

Hopefully 93 octane

 

right at 11.6 is the safest.......I think 12.1 is pushing it.

 

What will the ctr be in the b18c1 block and in the b18c5 block?

 

I have 12:1 Endyn running 93 with no problem. I wouldn't go any higher than that, and you better have some headwork to help out with air flow to burn it all. You also won't need to advance your timing to get you power with this setup!

 

I'm running 12.5:1 in an LS/VTEC (full P&P, ITR valves, Kawasaki springs, Ti. ret.,Skunk2 cams, CTR pistons, etc.)on 93 Octane at about 14 degrees (shooting for a J&S soon to set it at 18 deg. and let the bitch run!) - no probs. even in hot humid FL! Good Luck!


[Modified by GM2000ITR, 5:36 PM 11/8/2001]