good way to torque cam gears?
#3
Honda-Tech Member
Join Date: Nov 2002
Location: I told you to wait in the truck in Texas, United States
Posts: 2,753
Likes: 0
Received 3 Likes
on
3 Posts
Re: good way to torque cam gears? (lsvtec101)
The B16 head has small holes that you can insert a punch
through the camshaft holders into the cams to lock
into place..
through the camshaft holders into the cams to lock
into place..
#5
Honda-Tech Member
Re: good way to torque cam gears? (lsvtec101)
i know this is an old thread, but can someone chime in on other ways to do this? or is using the punch the best way to secure the cam gear from moving when torquing it?
#6
Honda-Tech Member
Re: good way to torque cam gears? (lsvtec101)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by lsvtec101 »</TD></TR><TR><TD CLASS="quote">how do i hold the cam while torquing the cam gear bolt? Thanks</TD></TR></TABLE>
If there is sufficient space between lobes and/or journals it is acceptable to put a pair of vice grips on the shaft. Put a rag in the jaws and use the minimal amount of pressure needed to keep the shaft from spinning. Make sure it does not spin or you will chew up the shaft.
If there is sufficient space between lobes and/or journals it is acceptable to put a pair of vice grips on the shaft. Put a rag in the jaws and use the minimal amount of pressure needed to keep the shaft from spinning. Make sure it does not spin or you will chew up the shaft.
#7
Junior Member
Join Date: Jul 2006
Location: Henderson, Tx
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
Re: good way to torque cam gears? (88DXCRX)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by 88DXCRX »</TD></TR><TR><TD CLASS="quote">The B16 head has small holes that you can insert a punch
through the camshaft holders into the cams to lock
into place.. </TD></TR></TABLE>
This has worked on several occasions for me and I believe is the correct way of doing it. Make sure the motor is at TDC and the holes should line up.
through the camshaft holders into the cams to lock
into place.. </TD></TR></TABLE>
This has worked on several occasions for me and I believe is the correct way of doing it. Make sure the motor is at TDC and the holes should line up.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post