hey i bought a lsvtec kit 2 years ago..and now im redoin the botem end and need to know what headgasket to use?..stock b16? or do i have to buy the GE headgasket??

 

the ge kit uses a vtec hg, but its re-drilled

 

so all i need to do is get a b16 HG nad drill out the dowl pin holes bigger?

 

???

 

I would just use a GE headgasket.

 

Don"t drill for the dowl pin. Spend $5-$10 buck on a ls-v dowl pin. You can find them anywere. Haft is big and haft is smaller.

 

i have the GE dowl pins..i bought the whole kit 2 years ago....i was askin if i can use a stock vtec headgasket or do i have to buy the GE headgasket agine?

 

you have the buy the GE HG.

I reccomend taking the head to a machine shop and having the opposite side's dowel holes of the head reamed out to 14mm. this will allow you to use a stock HG off an LS.

Good Luck
-Francisco