i recently put a mildy built b18 into my ef and now it wont start, it was converted over to multipoint from dpfi and everything was soldered and heat shrinked and then wraped

im getting fuel, i have comp. i have my timing set right, but with the spark i have some but i dont think its enuf

when i set the plug and wire on my head i get little faint sparks, when i put it to the core support i get big sparks and huge snaps

and last night i got the **** shocked out of me lol


but my main question then is do i need better grounds

i was told to add another ground cause its not grounded enuf

i have the main neg. batt cable one to the tranny
and then one from the rad. support to the valvecover stud

do i need more


any help is much appreciated

~jake

 

bump anyone

 

are you trippin any check engine lights? Also did you check the ignition control module?

 

no, no codes

the light comes on tho and ive had the ecu tested so it works

but i cant figuer out this crap

there is the icm located ???