Engine code from VAFC 2 (problem, help)
Thread Starter
Joined: Oct 2006
Posts: 1
Likes: 0
From: Lafayette, OR, USA
Engine code from VAFC 2 (problem, help)
I have 97 del sol vtec, with ITR ecu, and VAFC2. I get vtec failure engine code when holding my rpm's at an even point in high cam (vtec). However this doesn't occur when I accelerate, or decelerate through the vtec ban.
The things I have done to try and solve this problem: set changeover L>H 5500, H>L 5300. I was advised that would fix the problem. So far it hasn't. Any advice or knowledge of what may I should do. My next attempt is to double check wiring.
The things I have done to try and solve this problem: set changeover L>H 5500, H>L 5300. I was advised that would fix the problem. So far it hasn't. Any advice or knowledge of what may I should do. My next attempt is to double check wiring.
Thread
Thread Starter
Forum
Replies
Last Post