does any one know of a good ecu program to run on a gsr with a single butterfly manifold, that doesnt disable any sensors ? and i was only looking to extend my rev to 8400, and keep the vtec cross-over @ 4400? thaks for the help!

 

get a p28 and order a skunk2 chip off of ebay, you can get the p28 for around 100-150, the chip for 30-50, and then just have someone install it

 

would this be the same as say a mugen chip? because im picking up a mugen chip and a p28.

 

you can disable the butterfly selonoid from the ecu. I have never done it so search it.

 

no to sound liek a salesman, but yeah .. I have a really nice one for the P72 ecu which does that and retains knock sensor ... email me privately .. limiter at 9500rpm, vtec 4400rpm, secondaries (if oyu use them) at 5750rpm

greg

 

dude i want my rev limiter to only extend to 8400. and some of my friend have the skunk2 chip on their p72. and it rev's too much for me.

 

i picked up the mugen chip instead of the skunk2, its pretty damn nice, go for the mugen chip, pulls hard

 

i offer a XS engineering which has 8700rpm rev limt, but retaints all other sensors...