Ive ghot a dnx midpipe, but it narrows down to 1 7/8ths at the end. Thre are no muffler shops around my area that will cut and weld SS.

I was thinking about getting an ebay catback for around $150 shipped, and just using the midpipes. I have a WS2 axle back to bolt up to it.

Would it be worth it?

 

I would do it Dont be upset if the welds end up cracking though

 

cool, i just cant find a muffler shop that will weld stainless, or do any cutting.

 

just find a shop i live ina small place and even we have a place that will weld stainless

 

Im an amature and i weld stainless all the time for friends and such. I dont see why they couldnt. **** earlier this week i was welding some mild to stainless

 

i had an ebay 3" catback, it fit HORRIBLE, i had a local shop chop it up and make it fit right, the quality is good enough for the price, i dont regret it, i also changed the muffler to a vibrant flat black.

 

what parts fit wrong? just the angles of the flanges?

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by bigsyke &raquo;</TD></TR><TR><TD CLASS="quote">what parts fit wrong? just the angles of the flanges?</TD></TR></TABLE>
it just had some uncessasary bends and sat VERY low in places it didnt need to, also it went under the control arm at the lowest point so it sat even lower, i had it made to go over the control arm, used a vibrant muffler and had it moved up in some other places as well, if your not too low it should be ok.