Disconnecting Vafc
Thread Starter
Joined: Jan 2005
Posts: 10
Likes: 0
From: jax, fl, duval
Disconnecting Vafc
I have searched thoroughly to find an answer to this question but no luck. I dont have a manual and the vafc was hooked without me there. So is there anything I need to do to disconnect this or is it just merely removing the wires and resplicing them if needed? Any help would be greatly appreciated.
Re: Disconnecting Vafc (bill clinton jr.)
All of the wires but the VTEC and MAP sensor wires can simply be cut since they're wired in parallel. The VAFC is wired in series with the VTEC and MAP wires, so you have to rejoin those or it won't run with a MAP sensor input.
Re: (bill clinton jr.)
Take a look at the VAFC installation manual @ http://www.apexi-usa.com
Remember that you need to rejoin wires of the same color together. If you can keep that in mind, it'll make it a hard to mess up. You may need to solder and heat shrink an extra bit of wiring to give you more slack.
Remember that you need to rejoin wires of the same color together. If you can keep that in mind, it'll make it a hard to mess up. You may need to solder and heat shrink an extra bit of wiring to give you more slack.
Thread
Thread Starter
Forum
Replies
Last Post
