Just got my stage 2 crane cam put in my car... not really feeling a difference in power... barely got more top end and no more rev limit.. is this usual or should i have felt more of a bang?

 

Has the car been tuned or did you just install the cam and go? If not tuned, the lack of power from your upgrade has been found.

Phil

 

I was wondering the same thing if it had been tuned after the Cam install. What other mods are done to the motor?
if its been tuned them sorry to hear the disappointment...

 

What other mods are done to the car ???

 

its not gonna feel like a shot of nitrous or anything but you shoulda got a couple more hp out of it assuming that it was tuned with a decent engine management system.

If its not tuned, theres a good chance u are slower than before.

 

no..its not tuned ...but there is no dyno tuning around here and i wanted to wait a little bit b 4 i got hondata.. I got i,e,h. high flow cat. im lookin to port and polish next or get a new tb and intake mani... wat are your suggestions as to how i cud get more power other than those i mentioned?

 

AEM EMS
I had a bad experience one of Hondata's earlier models. Can't say anything about their newer ones.
In the meantime, adjustable cam gears?

I've heard of people driving down from NY to get tuned at P1 in NC. It's only a 6 hour drive and you can get trashed with the we-todd crew in Charlotte.

 

yes, adjustable cam gears and dyno tuning.

 

alrite..im on it..thanx. when dyno tuning with the adj cam gear... should u advance it a little each time to see where tha best results are or is there a certain spec to set it to.