how much will they raise the compression with stock head gasket, with spoon head gasket?
better yet which head gasket should i run?

if i mill the deck .0020th's what will compression be then? will there be clearance problems? and also which head gasket should be used? stock or an ultra thin?

what is the formula for figuring compression?


[Modified by chad, 10:14 PM 12/26/2001]

 

i think 11:1 ish?? Stock. but with your mods it might go skyhigh.

 

11.1 is right with .020 off it would be .4 more than with out it milled. also you have to rember to mill the rod a little more than 1mm on each side of the rod to make them fit.


[Modified by rainforest, 11:33 PM 12/26/2001]