Compression check
Thread Starter
Joined: Jan 2002
Posts: 209
Likes: 0
From: Altus Afb, ok, usa
Compression check
I have to do a compression check on my JDM B16 and i was wondering. How do i perform one of these? Also are there any difference in the jdm numbers vs the USDM bi6'scompression numbers?
Thanks
Evan
Thanks
Evan
Thread Starter
Joined: Jan 2002
Posts: 209
Likes: 0
From: Altus Afb, ok, usa
Re: Compression check (3rdGteg)
purchase a compression gauge.
I have the gauge i was looking on how to perform the check. I was told you had to put in the spark plug hole and crank the motor!!!
Member
Joined: Jul 2001
Posts: 1,214
Likes: 0
From: columbus, ohio
Re: Compression check (sensaiGen5)
Remove all four spark plugs, disable the fuel system, be sure battery is fully charged, hold throttle wide open, crank- watch the guage for the number of "puffs" it takes to reach peak PSI. repeat for each cylinder. If one cylinder reads low- squirt a little oil in it and recheck- if the number jumps significantly you probably have bad rings in there.
Thread
Thread Starter
Forum
Replies
Last Post
JSM-FA5
Honda Civic / Del Sol (1992 - 2000)
2
Sep 2, 2012 08:28 PM
sony224422
Honda Accord (1990 - 2002)
3
Dec 5, 2007 06:28 PM