I put in my fully built b18b, now awaiting turbo, and i was throwing code 14, no big deal - i got a new IACV and the code went away.

Now im throwing code 15 and code 20.

Code 15 = Ignition Output Signal missing or defective ignition output signal
Code 20 = Electrical Load Detector defective circuit or unplugged / defective sensor

common now... i fix 1 thing and 2 other break. What could be throwing those codes?

Also, FYI, when the car is no longer in "load" (eg: me giving it gas), it dies

 

update: i messed around with the ELS (electrical load sensor) and now it no longer displayes codes 15 and 20.... but now its back to the code 14 (IACV)... i just replaced it, wtf?

i think im gonna replace the plug, think that could be it?

 

thanks...

 

ryan make sure you have the clips in the right sensors... sounds stupid but it could be the problem. the clips for some of the sensors are the same.

sam

 

also code 15 should be from the blue wire on the dizzy

 

also check all your grounds

 

http://www.babcox.com/editorial/ic/ic19730.htm

eld article

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by 94goldjungsr &raquo;</TD></TR><TR><TD CLASS="quote">also check all your grounds</TD></TR></TABLE>

grounds are fine - my car had the same problem billy's had when starting (got a little paint on the ground = no connection = no starty = my wire brush it = then reattach = car startsasaurus.

I think im going to check my connectors, as i let RC connect my wire harness

 

fixed.... thank you sam...


and for the rest of you... i hope you all have problems with your cars and post on HT and have no one there to help you! kthx

 

for search purposes let it be known the clips were reversed between this and one for the charcoal canister i believe